Makita DUN461W Manuel D'instruction page 9

Adjusting the pipe length
CAUTION:
Always be sure that the tool is
switched off before adjusting the pipe length.
CAUTION:
When adjusting the pipe length,
be sure to attach the blade cover before adjusting
the pipe length.
CAUTION:
When adjusting the pipe length, be
careful not to pinch your fingers.
CAUTION:
Make sure that the lock-lever is
locked securely.
Loosen the lock-lever, then adjust the length of the pipe,
and then lock the lock-lever.
1
► 1. Lock-lever
Adjusting the front grip position
CAUTION:
Always be sure that the tool is
switched off before adjusting the position of the
front grip.
CAUTION:
When adjusting the position of the
front grip, be careful not to pinch your fingers.
CAUTION:
Make sure that the thumb nut is
tightened securely.
CAUTION:
Do not move the front grip beyond
the arrow mark.
To adjust the position of the front grip, loosen the thumb
nut by turning it counterclockwise, then adjust the posi-
tion of the front grip, and then tighten the thumb nut by
turning it clockwise.
► 1. Thumb nut 2. Arrow mark
1
2
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
NOTE: Before installing or removing the shear
blades, unfold the head of the tool so that the head is
straight to the tool body.
1. Place the tool upside down.
2. Remove 4 screws with a screwdriver and remove
the shear blades.
► 1. Screw
3. Remove the crank from the shear blades.
► 1. Crank
NOTE: The crank may remain in the tool.
9 ENGLISH
1
1