Setting Up Your Stand Mixer; Assembling Your Stand Mixer - KitchenAid 521.500 Instructions D'origine

SETTING UP YOUR STAND MIXER

Assembling Your Stand Mixer

To Attach Bowl
1. Turn Speed Control Lever to "0" (OFF).
2. Unplug Stand Mixer or disconnect power.
3. Raise Guard.
4. Place Bowl Lift Lever in down position.
5. Fit Bowl Supports over Locating Pins.
6. Press down on back of bowl until
bowl pin snaps into spring latch.
NOTE: If bowl is not securely snapped
into place, the bowl will be unstable and
wobble during use.
7. Lower Guard.
8. Raise bowl before mixing.
6
To Remove Bowl
1. Turn Speed Control Lever to "0" (OFF).
2. Unplug Stand Mixer or disconnect
power.
3. Raise Guard.
4. Place Bowl Lift Lever in down position.
5. Remove Flat Beater, Wire Whip,
or Dough Hook.
6. Grasp Bowl Handle and lift straight
up and off Locating Pins.
To Raise Bowl
1. Rotate lever counterclockwise
to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.