Operate The Machine; Care And Maintenance; Carbon Brushes - Varan Motors ZS180-A Manuel D'utilisation

Grinding Adjacent Edges【1-11】
Detachable brush segment can reach up to the adjacent edge with ease.

Operate the Machine

• Do not control the machine's head.
• Hold the machine with both hands.
• Before operating the machine, make sure every fastening handle is closed.
• Connect the machine to the main power supply.
• Before switching on the machine, keep the sanding head slightly away from the work surface.
• Start the machine for necessary sanding work.
Operate the machine with short length in narrow and awkward area.
Run the machine with medium length for higher walls.
Use the machine with longest length for ceilings.
 Do not over-press machine so that to avoid overloading! Press with proper pressure for better
grinding effects. Good grinding effects and quality are mainly decided by choosing the right
abrasive material.
• Once finishing the sanding task, switch off the machine.

CARE AND MAINTENANCE

Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a dry
place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
If a fault cannot be rectified, return the mixer to an authorized dealer for repair.
Cleaning
• Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as possible.
Clean the unit by rubbing it with a clean cloth or blow it clean using low-pressure compressed
air.
• We recommend that you always clean the unit immediately after using it.
• Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use cleaners
or solvents; these will attack the plastic parts in the unit. You must also ensure that water cannot
get into the inside of the unit.
Varan Motors

Carbon brushes

BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
ZS180-A