Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. line Guide(FiGure 6 )
For a straight 90º cut, use the right side of notch in the footplate. For
45º bevel cuts, use the left side. The cutting guide notch will give an
approximate line of cut. Make sample cuts in scrap lumber to verify
actual line of cut. This will be helpful because the blade type and
thickness could be different.
4. lOwer Blade Guard
The boards may guard is a safety feature which reduces the risk
of serious personal injury. Never use the saw if the lower guard is
missing, damaged, misassembled or not working properly. Do not rely
on the lower blade guard to protect you under any circumstance.
Your safety depends on following all warnings and precautions as well
as proper operation of the saw. Check lower guard for proper closing
before each use. If the lower blade guard is missing or not working
properly, please contact Customer service at the number indicated on
the front page of this manual, to be directed to a service centre near
you.
5. Blade CHanGe (FiGure 7 & 8)
•
Disconnect plug from power source.
•
Depress the spindle lock button
•
Counterclockwise turn to loosen and remove the blade retaining
bolt
•
Remove the outer blade bushing
•
Retract the lower blade guard to remove the saw blade. Do not
remove the inner blade bushing.
•
Place the new saw blade against the inner blade bush on the shaft,
making sure the arrow on the blade points the same direction on
upper guard.
•
Reinstall outer washer on the shaft with the larger flange against
the blade
•
Insert the blade retaining bolt and keep the spindle lock button
depressed
•
Securely tighten the blade retaining bolt by turning it clockwise
using the wrench supplied
note: The inner blade bush should not be removed. If removed, replace
it as shown in figure 8.
Fig. 7
Fig. 8
10
Publicité
Chapitres
Table des Matières
