Data-Logging - Consort C732 Mode D'emploi

Pre-set and start the data-logging:
1. Press SET until the display shows [SEt LoG] and press CAL to continue.
2. Select [Log dAtA] with Ù or Ú and press CAL to continue.
3. Choose with Ù or Ú between [LOG PH], [LOG MV], [LOG MS],... etc. Select the
desired mode and press CAL.
4. The display shows e.g. [dt=100]. Select the desired time interval (0...9999 s)
between the data-logging, with Ù or Ú and press CAL.
5. This step is skipped unless manual data-logging is chosen. Pre-set the time-
interval (dt) to zero and press CAL to continue (point 6 is skipped).
6. The display shows e.g. [n=40]. Select the desired number of values (1...500) to
be data-logged with Ù or Ú and press CAL.
7. The display shows [StArt ?]. Press CAL to start the data-logging according the
previous settings (a blinking [L] appears) or press MODE to return. After the
last value has been data-logged the display will show [End LOG]. When manual
data-logging has been selected, press PRINT to put a next measurement into
memory. In the meantime the display shows the logging-number e.g. [LOG 7].
Press MODE to return.
Continue with a next series of measure ments, without erasing the previous

data-logging:

1. Press SET until the display shows [SEt LoG] and press CAL to continue.
2. Select [Cnt LoG] with Ù or Ú provided the memory has enough capacity left!
Press CAL to continue to continue with a next series of measurements, without
erasing the previous data-logging.
3. Press SET to return.
View the stored values on the display:
1. Press SET until the display shows [SEt LoG] and press CAL to continue.
2. Select [LSt dAtA] with Ù or Ú and press CAL.
3. The display shows the first data-logged value in memory (a blinking [n] appears).
Press Ù or Ú to view all other values.
4. While pressing HOLD the corresponding date is shown.
5. While pressing RES the corresponding time shown.
6. Press PRINT to send the recalled data to a printer.
7. Press SET to return.
Send the stored values to a printer or computer:
1. Press SET until the display shows [SEt LoG] and press CAL to continue.
2. Select [Prt dAtA] with Ù or Ú and press CAL to print the data.
3. The display shows [PrintinG] while all data-logged values, including correspond-
ing dates and times, are sent to the RS232 output in the following format,
compatible with EXCEL™, LOTUS 123™,....The columns are separated by a TAB
character:
Identification No: 037
# VALUE UNIT
0001 7.34 pH
0002 7.21 pH
0003 7.08 pH
0004 6.71 pH
C732 C732
C CH H
23.7 2 13:19:57
23.7 2 13:20:57
23.8 2 13:21:57
23.8 2 13:22:57
D
29/01/95
29/01/95
29/01/95
29/01/95
Data-logging Data-logging
12 / 43 / 43