Adjusting Subwoofer Settings; Adjusting Source Levels - Pioneer Super Tuner 3 DEH-P6400 Mode D'emploi

Audio Adjustments

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press to select the
AUDIO
When the subwoofer output is on, you can
select the . Press
Sub-W2
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
(Hz).
2 Press 2 or 3 to select cut-off frequency.
Press 2 and (Hz) is displayed. Press 3 and
50
(Hz) is displayed. Only frequencies lower
125
than those in the selected range are output
from the subwoofer.
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
Press 5 or ∞ until you see the desired value
displayed.
.
Sub-W2
until
AUDIO Sub-W2 80
(Hz) or
50 125
to ).
+6 –6

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you wish to adjust (e.g.,
built-in CD player).
2 Press to select
AUDIO
Press until
AUDIO SLA
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
• – is displayed as the source
SLA +4 SLA –4
volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The AM tuner volume level can also be
adjusted with source level adjustments.
• The built-in CD and the multi-CD players are
both set to the same source level adjustment
volume automatically.
• External unit 1 and External unit 2 are set to
the same volume adjustment setting automat-
ically.
.
SLA
appears in the display.
En
Section
06
31