Using Subwoofer Output; Adjusting Subwoofer Settings; Using The High Pass Filter - Pioneer SUPER TUNER III FH-P4000 Mode D'emploi

Section
Digital Signal Processor
09

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Switching the rear output setting on
page 40.
1 Press to select
DSP
When the rear output setting is subwoofer, you
can select
SUB.W
appears in the display.
2 Press 5 to turn subwoofer output on.
appears in the display. Subwoofer
SUB.W :ON
output is now on.
• You can turn off subwoofer output by pressing
∞.
3 Press 2 or 3 to select the phase of sub-
woofer output.
Press 2 to select reverse phase and
in the display. Press 3 to select normal phase
and appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press to select the subwoofer setting.
DSP
When the subwoofer output is on, you can
select the subwoofer setting. Press
appears in the display.
80Hz
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
.
125Hz
38
En
.
SUB.W
. Press until
DSP SUB.W
appears
DSP
or
50Hz
2 Press 2 or 3 to select cut-off frequency.
Press 2 and
is displayed. Only frequencies lower than
125Hz
those in the selected range are output from the
subwoofer.
3 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
the level of the subwoofer (e.g.,
Press 5 or ∞ until you see the desired value
displayed.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play from
the front speakers, switch the HPF (high pass
filter) on. Only frequencies higher than those in
the selected range are output from the front
speakers.
1 Press
DSP
When the rear output setting is subwoofer, you
can select
the display.
2 Press 5 to turn high pass filter on.
HPF 80Hz
is now on.
• To turn high pass filter off, press ∞.
3 Press 2 or 3 to select a high pass filter
range.
until
Press 2 and
and
125Hz
than those in the selected range are output
from the front speakers.
is displayed. Press 3 and
50Hz
+6
to select .
HPF
. Press until
HPF DSP HPF
appears in the display. High pass filter
is displayed. Press 3
HPF 50Hz
is displayed. Only frequencies higher
to ).
–15
appears in