Initial Settings; Adjusting Initial Settings; Setting The Time; Switching The Warning Tone - Pioneer Super Tuner 3 DEH-P6400 Mode D'emploi

Section

Initial Settings

07

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press
FUNCTION
the following settings:
—
CLOCK WARN
TEL
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down
FUNCTION

Setting the time

This is used to set the time on the unit's clock
display.
1 Press
FUNCTION
Press
FUNCTION
display.
32
En
1
and hold until the unit turns
and hold until time
to select one of the initial
repeatedly to switch between
— — —
AUX DIM BRIGHT
BAND/ESC
until the unit turns off.
to select the
CLOCK
until the time appears in the
2 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.

Switching the warning tone

If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
— —
SW
1 Press
Press
FUNCTION
appears in the display.
.
2 Select
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
Warning :ON
.
to select
FUNCTION WARN
repeatedly until
on or off with 5/∞.
WARN
Warning
).
.
Warning
between on