Intended Use; Prohibited Uses - Evolution EVOMAG42 Notice Originale

www.evolutionpowertools.com
Eye protection should be worn at all
times when using this tool.
Hard Hat—Head protection should be
worn at all times whilst using this tool,
to protect from overhead hazards
Ear protection / Ear defenders should
be worn at all times whilst using this
tool, this tool exceeds 85dB(A)
Wear Dust Protection
Electrical enclosure -
risk of electric shock.
Read and understand
the instruction manual - before
operating this tool.
Caution ! / Attention !
Fuse
CE certification
ETL certification
Triman - Waste Collection
& Recycling
WEEE - Waste Electrical
and Electronic Equipment This
machine should be disposed of
as Electrical & Electronic Waste.

INTENDED USE

• This power tool is intended to be used for
drilling holes with annular cutters and twist
drills in an industrial environment.
• The machine is designed to be held
onto a ferrous surface using its
electromagnetic base.
• This power tool should be used in a
weather protected environment, and be
used with the accessories provided, or
Evolution Power Tools recommended
accessories only.
• The power tool can be used vertically,
horizontally and and in an inverted
position, provided the magnetic adhesion
and work environment allow.
WARNING: To prevent ingress of fluids
into the electrical system, cutting paste
should be used rather than cutting fluid
when using the machine in the inverted
position.

PROHIBITED USES

• This power tool should never be used without
a ground or protective earth connection.
• This power tool should not be used in a
potentially explosive environment.
• This power tool should not be used in a wet
or humid environment where water could
be drawn into the power tools cooling and
ventilation system.
• If the power tool is used in the inverted or
horizontal position, cutting fluids should
not be used to prevent ingress of fluids into
the electrical system. Cutting paste should
be used instead.
• This power tool should never be positioned
on a workpiece between the electrode and
ground of an arc type welder. Damage to
the machine will result as the welder will
ground through the power tools ground or
earth cable.
• This power tool should not be used
where the voltage is abnormally lower
than the rated voltage, subject to voltage
tolerances. Check the power tool rating
plate, check the voltage available.
WARNING: Operating on a lower than rated
voltage will result in the electro magnet
being at reduced power and the machine may
become insecure whilst cutting.
5
EN