Environmental Protection - Evolution EVOMAG42 Notice Originale

All motor bearings in this machine are lubricated
for life. No further lubrication is required.
Use a clean, slightly damp cloth to clean the
plastic parts of the machine. Do not use solvents
or similar products which could damage the
plastic parts.
WARNING: Do not attempt to clean by inserting
pointed objects through openings in the
machines casings etc. The machine's air vents
should be cleaned using compressed dry air.
Excessive sparking may indicate the presence of
dirt in the motor or worn out carbon brushes.
If this is suspected have the machine serviced
and the brushes replaced by a qualified
technician.
If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared
supply cord available through the service
organization.
ADJUSTING GIBS (Dovetail Gibs Slides)
WARNING: Only attempt this procedure with
the machine disconnected from the mains
power supply.
Note: S28MAG has two Gibs (Fig. 14) one of
which is adjustable.
Before every use:
• Check and lubricate the Gibs.
• Check the movement of the Cutting Head.
This must be smooth, exhibit no free play
and no binding anywhere along its range
of travel.
WARNING: The Cutting Head must not be able
to slide downwards under its own weight. It
should only move when the feed handles are
turned.
To adjust the Gib:
Position the Cutting Head so that the top edge
of the dovetail slide is level with the top edge of
the machines Gibs.
Note: The locking and adjusting screws are
located along the Left Hand edge of the
machines main slide. (Fig. 15)
www.evolutionpowertools.com
• Use hex key (supplied) to loosen slightly the
locking screws which lock the adjustable Gib
in place.
• Use a hex key (supplied) and starting with the
lowest adjusting screw, turn the screw
clockwise or counter- clockwise as required.
• Work upwards adjusting each of the screws
accordingly.
WARNING: There must be no free play,
sideways movement (wobble) or binding
detectable anywhere throughout the Cutting
Heads range of travel.
• Repeat the procedure several times. Ensure
that any free play, sideways movement or
wobble during travel has been completely
eliminated.
• When adjustment has been successfully
accomplished, retighten the locking screws.
Recheck the movement of the Cutting Head by
operating the feed handles.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Do not dispose of electrical appliances in
the household waste. According to European
Directive 2012/19 / EU on waste electrical and
electronic equipment and transposition into
national law, used electrical appliances must
be collected separately and recycled in an
environmentally sound manner.
Recycling alternative to the return request:
As an alternative, the owner of the electrical
appliance is obliged to cooperate with
the proper utilization in case of a property
assignment instead of return. For this purpose,
the old device can also be left to a take-back
point, which carries out a disposal within the
meaning of the National Closed Substance
Cycle and Waste Management Act. Accessories
and accessories without electrical components
attached to old appliances are not included.
18