GE AEE24 Manuel D'utilisation page 10

PREPARE THE AIR CONDITIONER
3
(continues)
Remove the shipping screws located on
E
the top of the case.
Remove the ground screws from each
F
side of the case. Keep them in a safe
location. NOTE: Be sure to save the ground
screws. You will need them later in the
installation.
Slide the air conditioner from the case
G
by gripping the base pan handle, lifting
up on the air conditioner, and pulling
forward. Have a second person brace the
case. Do not pull or lift on the styrofoam
discharge area.
Your unit may come with internal
H
packaging. This packaging must be
removed prior to installing the air
conditioner back into the cabinet.
Installation Instructions Installation Instructions
4
A
B
C
Do not
pull
or lift
in this
area—
damage
to the
unit may
result
FRONT
D
Bottom mounting rail
10
PREPARE THE CASE
Attach the top rail gasket to the bottom
of the top mounting rail.
Install the top mounting rail with 4 type A
screws from the inside of the case. Press
firmly to drive the screws into the gasket
and through the top mounting rail.
Top mounting rail
Slide each side rail onto the edge of each
according panel. The figure shows the
orientation of each accordion panel and
side retainer assembly relative to the case
from a top view of the unit.
Side Rail
Window Filler Panel
Side Rail
Window Filler Panel
Slide the left and right accordion panels
into the top and bottom mounting rails.
Top left
Top right