emerio PAC-125336.3 Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fan mode
When the fan runs at the set speed, the compressor does not run.
The adjustment of temperature in Fan mode is not effective.
5. Timer button
Auto-ON setting
When the appliance is OFF, press the timer button, the auto-ON indicator light will flash.
-
Press the timer increasing or decreasing button to select a desired auto-ON time from 1 to 24 hours.
-
The digital display and auto-ON indicator light will flash for several seconds, then the timer setting is
confirmed and the auto-ON indicator light will illuminate still.
The appliance will automatically turn on once the select time passed.
-
Auto-OFF setting
When the appliance is ON, press the timer button, the auto-OFF indicator light will flash.
-
Press the timer increasing or decreasing button to select a desired auto-OFF time from 1 to 24 hours.
-
The digital display and auto-OFF indicator light will flash for several seconds, then the timer setting is
confirmed and the auto-OFF indicator light will illuminate still.
The appliance will automatically turn off once the select time has passed.
-
To cancel the timer, set the time to 0 hour, or press into the timer setting, and when the digital display flashes,
press the timer button again. The auto-ON or auto-OFF indicator light will then turn off.
6. Sleep button (only active in cooling/heating mode)
Press the sleep button to activate the sleep mode. The sleep indicator light turns on.
In sleep mode, the fan turns to low speed automatically. The set temperature will increase 1 ℃ after
one hour, and increase 2 ℃ after two hours. After six hours, the appliance stops running automatically.
7. Swing button
Press the swing button to activate the swing function, and the cover above the air outlet will swing slowly.
To stop the swing, just press the button again.
NOTE:
The protective device may trip and stop the appliance in the conditions listed below.
Cooling
Drying
If the appliance runs in cooling or drying mode with door or window opened for a long time when
relative humidity is above 80%, dew may drip down from the air outlet.
To Shift the temperature unit between Celsius and Fahrenheit, long press both the temperature/timer
increasing and decreasing buttons ("
Drain water
1) Special reminder: There is condensing water recycling hidden in this appliance. The condensing water is
partly kept recycling between the condenser and the water tray. When the water level rises to the upper
level, the water-full code "E4" will be shown on the digital display to remind of draining water. The
water-full indicator light will also turn on.
2) Please cut off the power supply, move the appliance to a suitable place, pull out the stopper in the drain
Room temperature is over 43℃.
Room temperature is below 15℃.
Room temperature is below 15℃.
"&"
") simultaneously when the appliance is on.
- 9 -

Publicité

Table des Matières
loading

Table des Matières