Sabiana UP-TOUCH Mode D'emploi page 36

English
UP-TOUCH POWER UNIT HANDBOOK FOR WALL CONTROLS
» WM-AU accessory
AUTO
WM-AU is a control for wall installation.
The functions of the control are:
• Switching the fan coil unit on and off.
• Setting the desired room temperature (SET).
• Possibility of selecting the summer, winter,
automatic or ventilation operation cycle directly from
the control button.
• Manual selection of the three fan speeds.
• Automatic selection of fan speeds according to the
deviation between the set temperature and the room
temperature.
• Thermostatic opening or closing control (ON-OFF),
both in the summer and winter cycle, of the water
valve (two-pipe system) or the two valves (four-pipe
system).
• Function check of the special Electronic Filter
mounted on the fan coil unit in IAQ version
(accessory)
• Checking the operation of the electrical resistance
when mounted as an accessory.
• Activating/deactivating the Energy Saving function
For any maintenance, make sure you have
disconnected the power supply.
Install the wall-mounted control unit taking care to
place it on the wall of the room to be conditioned at
a height of about 1.5 m, on an intermediate wall and
away from heat sources and cold air draughts.
• TECHNICAL FEATURES OF THE CONTROL
1) Purpose of the control device: control of fan coil units
2) Thermostat adjustment range: from 15 to 30 °C
3) working temperature: 0/50 °C
4) storage temperature: -10 / +50 °C
5) container: ABS V0
6) protection: IP 20
7) connection via printed circuit terminal board
8) Insulation class: II
9) Cross-section of leads: Min. 0.50 mm² - Max. 1.5 mm²
10) Reference standard: CEI EN 60730
(C 9066632)
odE
AUTO IAQ
C
°
AUTO IAQ
AUTO
C °
h = 150 cm
AUTO IAQ
AUTO min
C °
50 cm
36
AUTO
IAQ
AUTO
AUTO IAQ
AUTO
° C
C °