GE eBike Mode D'emploi page 58

P r o g r a m s
1 . W H O
2 . B A L
3 . H o l l m a n n
4 . S T D . F r a n c e
5 . S t a n d a r d
S e l e c t
Figure 6-4 Selecting a protocol
P r o g r a m
6 .
I n i t . L o a d
S t e p t i m e
L o a d s t e p
S e l e c t
Figure 6-5 Editing a protocol
P r o g r a m
6 .
I n i t . L o a d
S t e p t i m e
L o a d s t e p
S e l e c t
Figure 6-6 Initial load displayed in reverse video
22
Configuration
2 5 W
2 m i n
2 5 W
2 5 W
2 m i n
2 5 W
eBike with Control Terminal PC
Editing the Test Protocol
The first 5 test protocols are fixed and cannot be changed.
Protocols 6 through 15 can be edited as needed. The
protocol details to edit are:
– initial load
– step time
– load step (load increment)
On the protocol editing screen (Figure 6-5) highlight
the parameter to change with the bar cursor (e.g. Init.
Load) and confirm your choice with Select.
The initial load is displayed in reverse video (Figure 6-6).
Now use the right and left softkeys to change the
initial load and confirm the new value with Select.
Edit the other parameters in the same way, when needed.
Quit the configuration mode with
These are the adjustment ranges:
Parameter Adjustment Range
initial load 20 to 100 watts
step time 1 to 30 minutes
load step 1 to 400 watts
.
2018112-001 Revision B