Getting Started; Unpacking; Hookup Overview - Sony SDP-E300 Mode D'emploi

Getting Started

Unpacking

Check that you received the following items with your
processor:
• Remote controller (remote) (1)
• Size AA (R6) batteries (2)
Inserting batteries into the remote
Insert two size AA (R6) batteries with the + and – on
the battery compartment. When using the remote,
point it at the remote sensor g on the processor.
When to replace batteries
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the
processor, replace both batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
GB
4

Hookup Overview

The processor allows you to connect and control the
following audio/video components. Follow the
hookup procedures for the components that you want
to connect to the processor on the pages specified. To
learn the locations and names of each jack, see "Rear
Panel Descriptions" on page 17.
TV/VCR Hookups (5)
TV
Speaker System
Hookups (6)
VCR
Amplifier
for front
LD player
speakers
Control Amplifier,
Rear
CD player, etc...
speaker
(L)
Audio Component
Hookups (5)
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the mains lead until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum
and noise.
• When connecting an audio/video cable, be sure to
match the colour-coded pins to the appropriate jacks
on the components: Yellow (video) to Yellow; White
(left, audio) to White; and Red (right, audio) to Red.
Centre
speaker
Active Rear
woofer
speaker
(R)