Removing The Wall Brackets - Vertical Model - Atlantic Galapagos Rfm6H Manuel D'utilisation

REMOVING THE WALL BRACKETS - VERTICAL MODEL

REMOVING THE WALL BRACKETS - VERTICAL MODEL
Leave the radiator flat on the ground.

Open the flaps at the base of the box.

Remove the blocks from the centre of the radiator and leave

the others on the radiator.
Move the upper and lower blocks approximately 5 cm to gain

access to the wall brackets.
Remove the 2 bolts from each wall bracket using the key provided

at the back of the control panel (these 4 bolts are not used again).
Unclip the plastic covers at the ends of the wall brackets.

These must be retained.
Remove the top wall bracket and the bottom wall bracket.

These must be retained.
47
EN