Vestfrost AKG/S 337 Mode D'emploi page 19

Bottons
SET
To display target set point; in programming mode it selects a parameter or confirm an opera-
tion.
To enter fast access menu In programming mode it browses the parameter codes or increases
the displayed value. (DOWN); n programming mode
In programming mode it browses the parameter codes or decreases the displayed value. Push
it for 3s to start a manual defrost
DATA
Export data from button
To switch off the light in the door (only models with light in the door
REC
Log activation and deactivation from button (Password protected)
How to see and modify the
setpoint
How to: See the Set point
1. Push and immediately release the SET
key: the display will show the Set point
value.
2. Push and immediately release the SET
key or wait for 60 sec to display the tem-
perature in the unit.
How to: Change the Set point
1. Push the SET key more than 2 sec to
change the Set point value.
2. The value of the set point will be display-
ed and the "°C" LED will start blinking.
3. To change the Set value push the UP or
DOWN arrows within 60 sec.
4. To save the new set point value, push the
SET key again and wait for 3 sec.
NOTE: To exit without making any change
to the set point, push the SET key or
wait 60 sec.
Clock settings and RTC alarm
reset
1. Push the UP key once, to acces the
menu.
2. The display shows H∩, then push SET.
3. The parameters for setting time and date
occurs. To set the parameter push SET,
push the UP or DOWN button to change
the parameter. Confirm by pushing SET.
The time and date parameters:
Hur: hour
∩in: minutes
Udy: weekday
dAy: date
∩on: month
yEA: year
To exit: Press SET + UP keys for about 10
sec. or wait 60 sec.
19
GB