GE Profile PCDBI01KITFS Instructions D'installation page 4

PREPARE FOR DRAIN HOSE
A2
CONNECTION
■ The molded end of the drain hose will fit 5/8" through
1" diameter inlet ports on the air gap or waste tee.
IMPORTANT: Do not cut
this portion of hose.
■ Determine size of inlet port. If required, cut drain hose
connector on the marked line, to fit the inlet port.
CONNECT WATER SUPPLY AND
A3
DRAIN HOSES TO DISHWASHER
■ Water Supply Hose: If not installed, install rubber
washer in one end of water supply hose. Thread the
water supply hose onto the inner connector on the
rear of the dishwasher. Hand tighten and use pliers
to tighten hose between 1/8 and 1/4 turn beyond
hand-tight.
■ Drain Hose: If not installed, install rubber washer in
one end of drain hose. Thread the drain hose onto
the outer connector on the rear of the dishwasher.
Hand tighten and use pliers to tighten hose between
1/8 and 1/4 turn beyond hand-tight.
Water
Supply
Hose
4
Installation Instructions
Cutting Line
Drain
Hose
OPTIONAL - REPLACE
A4
DECORATIVE TOEKICK WITH
STAINLESS STEEL APPEARANCE
INCLUDED WITH KIT
■ Skip to step A5 if
not replacing the
toekick.
■ Remove the two
screws securing the
decorative toekick
to the dishwasher.
Remove toekick.
REMOVE PLUGS TO PREPARE
A5
TO INSTALL FRAME
■ Remove the interior
plug buttons and push
the rubber plugs from
the inside of the tub.
Access to these four
holes will be needed
later in the installation.
SECURE FRONT FRAME TO THE
A6
DISHWASHER
■ Secure the
dishwasher to the
frame through the
top mounting holes
using the 2 Type B
screws and nuts.
■ Replace top plug
buttons.
IMPORTANT: Make sure to securely replace the top
plug buttons to ensure a waterproof seal inside the
dishwasher.
Remove toekick screws
and decorative toekick
Remove
Plug
Buttons
Screws
and
Nuts
31-4000300 Rev 4