AKG MicroMic III Série Mode D'emploi page 15

the phantom power supply to the desired
balanced input.
You may connect any AKG phantom power sup-
ply (2) to an unbalanced input, too.
Use a cable (3) with a female XLR connector and
TS jack plug:
XLR Phantom
1
Fig. 2: Connecting to an unbalanced input.
1. On the XLR connector (4), use a wire bridge to
connect pin 1 to pin 3 and the cable shield.
2. Connect the inside wire of the cable to pin 2
on the XLR connector (4) and the tip contact
of the jack plug (5).
Unbalanced cables may pick up interference
from stray magnetic fields near power or lighting
cables, electric motors, etc. like an antenna.
This may introduce hum or similar noise when
you use a cable that is longer than 16 feet (5 m).
The optional B 29 L battery supply allows you to
connect the microphone to balanced or un-
balanced inputs with no phantom power.
2 4
3
2 Interfacing
2.2.2 Connecting
to Unbalanced
Inputs
Refer to fig. 2.
5
Note:
2.3 C 418
2.3.1 Using the
Optional B 29 L
L
III
15