AKG MicroMic III Série Mode D'emploi page 14

1 Description
2 Interfacing
2.1 Introduction
Important!
2.2 C 418
III
2.2.1 Connecting
to Balanced
Inputs
Refer to fig. 1.
Phantom
XLR
1
Fig. 1: Connecting to a balanced input.
Refer to fig. 1.
14
phantom power adapter, or AKG bodypack
transmitters.
The C 418
fore needs a power supply.
Using any power supply other than those
recommended by AKG may damage your
microphone and will void the warranty.
PP 1. Connect the phantom power adapter (1) on the
microphone cable to a balanced XLR micro-
phone input with phantom power.
2. Switch the phantom power on. (Refer to the in-
struction manual of the unit to which you
connected your microphone.)
2
3. If your mixer provides no phantom power:
Connect the phantom power adapter (1) to an
optional AKG phantom power supply (2) (N 62 E,
N 66 E, B 18, B 15) and use an XLR cable (3)
(e.g., an optional MK 9/10 from AKG) to connect
is a condenser microphone and there-
III
1
3
XLR