Parent Unit; Using Your Baby Monitor - Philips Skm7489Nc Mode D'emploi

DECT3_Book.qxd 28-05-2005
5 Place the parent unit in the charging base (B-15).
> The POWER light (B-16) lights up red.
6 Leave the parent unit in the charging base until the batteries
are fully charged (at least 16 hours).
> The POWER light (B-16) will stay red, even when batteries
are fully charged.
> When the batteries are fully charged, the parent unit can be
taken out of the charging base and used cordlessly for up
to 12 hours.
> When the battery indicator (
empty and the parent unit beeps, battery power is low.
Place the parent unit in the charging base (B-16) to
recharge the batteries.
The parent unit is now ready for use!
1 Position both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press and hold the On/Off (y) button (A-1) on the baby unit
for 2 seconds.
> The nightlight (A-10) lights up briefly.
> The display light (A-11) lights up indicating the current
room temperature.
> Not LinKed lights up on the display and the LINK light
(A-3) starts blinking red, searching connection with the

parent unit.

3 Press and hold the On/Off button (y) (B-6) on the parent
unit for 2 seconds.
> The sound level lights (B-9) briefly light up orange.
> The display (B-8) lights up.The battery indicator (
the room temperature light up in the display.
> The LINK light (B-3) lights up red briefly then starts
blinking green, searching connection with the parent unit.
08:56 Pagina 9
Getting your baby monitor ready for use
) in the display (B-8) is

Using your baby monitor

) and
EN
> 1 m / 3 feet
1m / 3 ft
9