Mounting The Hood Body; Connections - Atag Ws9211Em Notice D'utilisation

INSTALLATION

Mounting the hood body

Connections

EN 14
• Before attaching the hood body, tighten the two screws Vr located
on the hood body mounting points.
• Hook the hood body onto the screws 12a.
• Fully tighten the support screws 12a.
• Adjust the screws Vr to level the hood body.
Ducted version air exhaust system
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120mm, the
choice of which is left to the installer. First install the dumper 10.
Remove any activated charcoal filters.
To install a ø 150 pipe
• Install the pipe on the dumper 10.
• Fix the pipe in position using sufficient pipe clamps (not supplied).
To install a ø 120 pipe
• Install the pipe on the dumper 10.
• To install a ø 120 mm air exhaust connection, insert the reducer
flange 9 on the dumper 10.
• Fix the pipe in position using sufficient pipe clamps (not supplied).