Pioneer DR-R7181 Mode D'emploi page 9

1. When inserting a drive, be sure to
place the drive on the changer guide
rails and push the drive in until the
lock lever on the drive shifts to the
locked position. Maybe you can hear
a clicking sound then.
Drive
Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
2. Connect the power cable.
When the power cable has been
connected, the wiring monitor indicator
on the rear of the drives (orange) will light
up.
When the termination switch of the drive
is set to on, the termination indicator
(green) will light up.
Power cable
Wiring monitor
indicator
Termination indicator
3. Connect the changer interface cable.
Guide rails
NOTE:
Connect the changer interface cable to the
connector corresponding to the bay in which
the drives have been installed. (Note that labels
are affixed to connectors indicating the
corresponding bay number.) Note that it is
extremely important to do this, as connecting
the changer interface cable to a neighboring bay
will result in damage to discs and the disc
transport mechanism.
4. Connect SCSI cables.
The way in which SCSI cables should be
connected differs depending on how the
changer is to be configured. For further
information on how to connect SCSI cables,
see the operating instructions for the DRM-
7000 disc changer.
TO INSTALL THE DRIVE
When the changer interface cable has
been connected, the wiring monitor
indicators will flash at two-second
intervals.
Wiring monitor
indicator
Changer interface cable
9
<DRC1111>
En