Multibrackets M Universal Long Reach Manuel D'installation page 6

INSTALLATION
1 Attach the Wall Plate Template (BB) to the wall at the desired installation
2). Ensure the Wall Plate Template (BB) horizontal
and mark 6 lag bolt installation locations on the stencil and the wall.
3). Use a 3/8" (10 mm) drill bit to drill a pilot hole on the wall with a depth of at least 2.6"
(65mm). Please note, failure to drill pilot holes may result in the lag bolt heads snapping
during installation.
Insert 6 x Wall Anchors (l) into holes. Secure the Wall Plate to the wall
with 6 x Lag Bolts (H) and 6 x Washers (H).
OPTION 2: Concrete/Brick
www.multibrackets.com
Wall Installation
alignment is verified with a bubble level
65mm
2.6"
A WARNING
• Tighten screws so that wall plate is firmly attached,
but do not overtighten. Overtightening can damage
screws, greatly reducing their holding power.
location.
10m