Support mural pour ecrans lcd, tft et plasma (4 pages)
Sommaire des Matières pour Multibrackets M Universal Long Reach
Page 1
Oönyi€s €YKaTåcnaong Manual de instalaciön Asennusohje Installation Manuel n-r-p-l nnt-nn Szerelési kézikönyv Manuale di installazione Montavimo instrukcija UzstädiSanas rokasgrämata Installatie handleiding Installasjonshåndbok Instrukcja instalacji Manual de instalaqäo Manual de instalare no YCTaHOBKe InStalaöny manuål Navodila za monta20 Installationsmanual Montaj kilavuzu www.multibrackets.com...
Page 2
Le viti in dotazione potrebbero rivelarsi non adatte per il materiale della parete, del sof-fitto 0 del pavimento. Sostituitele quindi con viti piü idonee in Caso di necessitå. Nel caso riscontriate problemi nel montaggio di questo prodotto, consultate un tecnico specializzato. LCD'S. www.multibrackets.com...
Page 3
Intenäea for Incoor use ony ana any multibrackets.com n•cessones 2 PERSONS RECOMMENDED The content Of this manual is subject to change without further notice. The latest version Of this manual can be found online under the product name on the website: www.multibrackets.com www.multibrackets.com...
Page 4
• The manufacturer will not be liable for any damages arising out of the use of , inability to use, the product. Past list (8x65)-6pcs (M4x16)-4pcs (016xØ8.2x1.5)-6pcs (M5x16)-4pcs (M6x16)-4pcs Plastic Anchor -6pcs (M8x25)-4pcs (016xØ6.2x1.5)-4pcs Safety Brackets -4pcs (M5x8)-4pcs (M8x45)-4pcs wrench-I pcs Wall Plate Template -1 pcs www.multibrackets.com...
Page 5
Overtightening can damage screws, greatly reducing their holding power. Secure the Wall Plate to the wall with 6 x Lag Bolts ( H) and 6 x Washers (H). NOTE: Do not use Wall Anchor (l) for wood stud installation. www.multibrackets.com...
Page 6
Overtightening can damage screws, greatly reducing their holding power. Insert 6 x Wall Anchors (l) into holes. Secure the Wall Plate to the wall with 6 x Lag Bolts (H) and 6 x Washers (H). www.multibrackets.com...
Page 7
Ensure both of the bolts are tightened at each locking bar's position to prevent the arms from sliding off the wall plate. WARNING: FAILURE TO INSTALL THE LOCKING BARS ADEQUATELY MAY RESULT IN THE ARMS AND THE TV FROM SLIDING WALL PLATE. Take www.multibrackets.com...
Page 8
Use the bolts matching the TV bolts holes, on the arms, attach the two safety screws or B+E or C+E or D or G behind the VESA plate to lock in the VESA plate to the arms,as shown below. www.multibrackets.com...
Page 9
Ensure the TV brackets sit flat with the back of the TV Hanging TV on The wall Mount Arms Lift the TV up (two persons recommended) and hang the TV brackets on to the wall mount extension bars. www.multibrackets.com...
Page 10
The mount allows up to 5 degrees of leveling adjustment post installation. To adjust the level of the TV, place a bubble level on top of the TV, loosen the 2 x G bolts located behind the VESA plate, level the TV and tighten the 2 x G bolts to lock the TV in position. www.multibrackets.com...
Page 11
NOTE: IF THE TV TILTS DOWN AFTER A PERIOD OF USE, CHECK THE TILT ADJUSTMENT LEVER TIGHTNESS TIGHTEN IF NECESSARY. _50_ +100 Use the integrated cable management clips on the arms to route cables to the back or side of the TV. Cable www.multibrackets.com...