SAFETY INSTRUCTIONS
While every attempt is made to ensure the highest degree of protection
in all equipment, we cannot guarantee freedom from injury. The user
assumes all risk of injury due to use. All merchandise is sold on this
condition, which no representative of the company can waive or
change.
• The fan is only for intended use as described in this manual. All other uses,
not recommended in this manual, may cause fire, electrical shock or injury
to persons.
• This fan is intended for household use.
• To protect against electrical shock, do not immerse fan, plug or cord into
water or spray with liquids. KEEP AWAY FROM ALL LIQUIDS.
• Close supervision is necessary when any appliance is used near children.
• Always unplug the fan when it is not in use, when moving fan from one
location to another, and before cleaning.
• Avoid contact with moving parts. Never insert fingers, pencils or other
similar objects through the guard.
• Do not operate in the presence of explosive or flammable fumes.
• Do not place fan or parts near an open flame, cooking or other heating
appliances.
• Do not operate fan with a damaged cord, plug or after the fan suffered
malfunctions or has been dropped or damaged in any manner.
• The use of attachments not recommended by manufacturer may be
hazardous.
• Do not use outdoors.
• Do not let cord hang over the edge of a table or counter, or let it touch any
hot surfaces.
• To disconnect, grip plug and pull from wall outlet, never yank the cord.
• Always use on a dry level surface.
• Do not operate without fan lattice/grille properly in place.
•
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved.
•
Children shall not play with the appliance.
•
Cleaning and user maintenance shall not be made by children without
supervision.
WARNING !
•
remove the guards during use or cleaning.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Never use without the guards in place. After assembly, do not
EN
2