Installing The Philips Oneup Floor Cleaner - Philips Oneup Xv5113 Mode D'emploi

English
6

Installing the Philips OneUp Floor Cleaner

1 2
1
2
2 Connect the charging cable to a USB-A adapter and insert the adapter into
the wall socket.
Note: The adapter is not supplied with the appliance. Only use a safety extra
low voltage approved adapter with an output rating of 5.0 V DC 1.0A 5.0W and
USB-A connector type.
Note: After charging, remove the adapter from the power outlet and pull the
charging cable out of the appliance. Then close the sealing cap.
Warning: Store and charge the appliance in a stable position at a
temperature above 5 °C and below 35 °C in a dry environment.
Install the Philips OneUp Floor Cleaner (XV1892) into the clean water tank lid
before first use.
1 Remove the clean water tank from the appliance and take off the lid.
2 Turn the cap counterclockwise (1) and pull it upwards (2) to remove the cap
from the Philips OneUp Floor Cleaner bottle.
3 Insert the bottle into the clean water tank lid by pushing it upwards (1) and
then twisting it clockwise (2). You can hear a 'click' sound when the bottle is
placed correctly.