Connect The Power Cord - Costway Land Rover Defender 110 Svx Mode D'emploi

6. Install the winch frame
Align the winch frame with the hole under the front of the car and
insert it tightly.

7. Connect the power cord

Connect the power
cord to the battery.
Then turn on the
power to check the
circuits.
8. Install the seat
First align the backrest with the body position and install it, then align
the seat with the position under the backrest and tighten the screws
with a screwdriver.
14
9. Install the rear bracket
First, connect the two rear brackets and crossbar, and tighten the
interface with screws. Then, install the rear bracket into the
corresponding hole at the rear of the vehicle.
Charging steps are as follows:
Step 1: Find the charge hole under the seat.
Step 2: Connect the charger cord to the charging point.
Step 3: Connect the charger to the power socket.
15