Table des Matières
Publicité
To assemble dust bin:
➢ ➢ Reinstall upper portion of dust bin
onto air guide so that the locking
screws pass through the holes in
the upper portion.
➢ ➢ Using alignment marks on the
fastener ring and dust bin, place
fastener ring onto dust bin and
rotate to lock in place.
➢ ➢ Place the dust bin lid on the upper
portion of the dust bin using
alignment slots, and rotate until the
lid locks in place.
➢ ➢ Reinstall pre-filter by using the
alignment ribs on the pre-filter to
align with the ribs on the upper
portion of the dust bin.
➢ ➢ Press into place. A noticeable
"click" should be heard.
➢ ➢ Reinstall lower portion of the dust
bin by aligning ribs on the upper
portion with the UNLOCK ribs on
the lower portion.
➢ ➢ Rotate until ribs from the upper
portion of the dust bin align with the
LOCK ribs.
NOTE: If lower portion of dust bin
does not fit properly check pre-filter
installation.
- 44 -
Publicité
Table des Matières
