Create Popcorn Maker Studio Mode D'emploi page 4

Before using any electrical appliance, always observe the following basic
safety precautions.
• Do not touch hot surfaces. Use the handles to move the appliance.
• To protect against electrical shock, do not immerse cord in water or other
liquids.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of ex-
perienceand knowledge,unlessthey havebeengiven supervisionor
Instruction concerning use of the appliance by a person responsible
for your safety.
• Close supervision is necessary when any appliance is used by or near
children.
• Children must be supervised to ensure that they do not play with the ap-
pliance.
• Unplug the appliance from the outlet when not in use and before clean-
ing. Allow to cool down before putting on or taking off parts and before
cleaning the appliance.
• Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions. If the appliance or the cable is damaged, con-
tact customer
• The use of accessories not recommended by the appliance manufactur-
er may cause injury.
• Do not use the appliance outdoors.
• Do not let cord hang over edge of kitchen table or bench, or touch hot
surfaces.
• Alway s connect t heplugto theappliance f irst,thenPILI}thecordinto
the wall outlet. To disconnect, turn any control to the 'off position, then
remove plug from wall outlet.
• Do not place the appliance on or near a hot gas or electric burner, or in a
hot oven.
• Do not use the appliance for other than its intended use.
• When the appliance is in operation, never leave it unattended.
• Great care must be taken when popping the popcorn. Always turn the
unit upside down on a counter so that residual hot oil or escaping water
does not cause burns.
• Never handle or replace the power cord that carries the product, this
could cause an electric
• This appliance is not designed to be operated by means of a timer or sep-
arate remote control system.
• For safety reasons, a damaged or faulty power cord should only be re-
placed by the brand's comeback center.
SECURITY
service.
shock or burns.
INSTRUCTIONS
ENGLISH 5