Powerpack; Optional Powerpack With Belt And Charger; En Option Bloc D'alimentation Avec Ceinture Et Chargeur; Opcional - Fuente De Energía Con Correa Y Cargador - Wahl Lister Libretto Mode D'emploi Et Liste Des Pièces Détachées

Powerpack

The pocket-sized Lister Powerpack gives you the freedom to clip where you please
Charging the Powerpack
• Charge using the supplied Lister charger only (15V
• Charge indoors only. The charger must be kept dry at all times
• A new Powerpack must be charged before first use. It will not reach full capacity until it has been fully charged and
discharged 3 times. This means that the clipping time may be reduced for the first 3 times it is used
• Connect the Powerpack to the charger cable and plug the charger into the mains
• A full charge takes between 11 and 13 hours
• Partial charging and discharging will not damage the Powerpack. The energy stored is proportional to the time spent
charging
• Overcharging will not damage the Powerpack, but it should not be left permanently charging when not in use
Clipping using the Powerpack
• Ensure that the Powerpack is securely clipped to a belt or to clothing, or held firmly in a pocket. Connect the clipper
lead to the Powerpack
• Oil the blades every 5-10 minutes (see Figure 6)
• Disconnect when not in use, and before removing or fitting blades
• A full charge lasts approximately 2 ½ hours. As soon as the clipper speed drops noticeably, stop clipping and
recharge the Powerpack
Overload protection
• The Powerpack is fitted with a resettable fuse to protect the battery and clipper from overloading. This will trip if there
is a problem, such as blunt or clogged blades, lack of oil, excessive blade tension, or if the Powerpack needs
recharging
• The problem must be rectified before resuming clipping. Disconnect the Powerpack, and then clean and oil the
blades. Press the RESET switch to resume clipping (see Figure 8)
• Never hold the RESET switch down to prevent it from tripping. Continuous use of the RESET switch may damage the
resettable fuse and the clipper
Maintenance and storage
• Regularly check the connections and the charger cable for damage
• Store at room temperature in a clean dry place, out of the reach of children, and away from reactive chemicals or
naked flames
• The Powerpack may be stored fully charged or discharged. It will gradually lose its charge over long periods. If it
loses all charge it will not regain full capacity until it has been fully charged and discharged 2 or 3 times. So the
clipping time may be reduced for the first 3 times it is used after storage
Technical information
• Voltage
• Overload Current
• Capacity
• Weight
• Battery cells
• Casing material
4
/ 400mA)
12V
4.5A
4300mAh
0.8kg
10 x 1.2V Nickel Metal Hydride cells
PC+ABS