Blower Attachment; Use - Otto XL-202 Mode D'emploi

Blower Attachment

The blower attachment can be used to easily remove accumulations of dust and dirt as well as
liquids.

use

cAutIOn!
❐ The device must be connected only to a mains socket that has been properly installed. The
socket must also be readily accessible after connection. The mains voltage must match the
technical data for the device (see the "Technical Data" chapter). Only use suitable extension
cables whose technical data is the same as that of the device.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e. g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Inflammable or explosive substances
– Very fine dust (e. g. concrete dust), ash or toner
– Pointed, hard objects such as e. g. large pieces of broken glass
01375_DE-GB-FR-NL_V1.indb 25
1. Remove the back cover of the housing by unscrewing the cover
in the anticlockwise direction.
2. Remove the exhaust air filter.
3. Screw on the blower attachment by turning it clockwise.
4. Plug the wide end of the extension hose onto the blower
attachment.
25
14.09.12 08:37