Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 334T Manuel D'utilisation

Symbols on the machine:

WARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Never let the guide bar tip come in contact
with any object.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Recommended cutting equipment
in this example:
- Bar length 14 inches
- Max. nose radius 7 Teeth
- Chain type Husqvarna H36
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value
without triggering the brake, for the bar and
chain combination on the label.
Chain brake, activated (right)
Chain brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
2 – English

KEY TO SYMBOLS

Symbols in the operator's
manual:
Switch off the engine by moving the
stop switch to the STOP position before
carrying out any checks or
maintenance.
Working position
Choke
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.