Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" (6 mm) and
5/16" (8 mm) nut driver
(recommended)
Tape measure
Utility knife
Caulking gun and
compound (new vent
installations)
Wire stripper
(direct wire installations)
4
#2 Phillips screwdriver
Level
Pliers
Tin snips (new vent
installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tools needed for gas installations:
8" (203 mm) or 10" (254 mm)
pipe wrench
Pipe-joint compound
resistant to propane gas
Parts supplied (all models):
Leveling legs (4)
Parts needed (steam models):
"Y" connector
Rubber washer
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
with a pedestal or a stack kit.
Parts needed (not supplied with dryer):
Vent clamps
■
Vent elbows and vent work
■
8" (203 mm) or 10" (254 mm)
adjustable wrench (for gas
connections)
2' (0.6 m) inlet hose
5' (1.52 m) inlet hose
Publicité
Table des Matières
