Festo DPA−63−10 Notice D'utilisation page 16

DPA−...
Please note
S Take these correlations into account:
Setting
The set high pressure is less than the input
pressure.
The input pressure is always min. 2 bar less
than the set high pressure.
Increasing the high pressure.
Air volume/current on the input side too low.
Maximum regulator setting:
DPA−...−10: typ. 10 bar ... max. 14 bar
DPA−...−16: typ. 16 bar ... max. 22 bar.
Complete the following steps:
S
1. Pull the adjusting knob away from the
housing (only with DPA−...−10).
2. Turn the adjusting knob 5 as far as
possible in an anti−clockwise direction
(status as supplied).
3. Pressurize connection 1 on the DPA−...
with the input pressure.
4. Turn the adjusting knob in a clockwise
direction until the desired high pressure is
set.
The pressure status is monitored by addi
tional control manometers in accordance
with the section Accessories"
(see Fig. 10).
Manometer (A): input pressure
Manometer (B): high pressure
To be locked:
5. Push the adjusting knob towards the
housing (only with DPA−...−10).
16
Reaction
The pressure regulator on the DPA−...
exhausts until pressure is equalized.
DPA−... reaches the set high pressure.
Increasing the air consumption.
High pressure fluctuates.
The max. output pressure can be ex
ceeded by up to 40 % (dispersion of the
regulator springs due to production).
5
Fig. 8
Fig. 9
6
(A)
Fig. 10
Festo DPA−... 0405b English
(B)