Extreme Max 3005.3877 Instructions D'installation

-naäuC7$
Includes:
1. Flag Holder Bracket x 1
2. Quick Release Pin x 1
3. Wing Head Thumb Screw x 1
4. Pivot Lock
Read, Follow, and Save These
Instructions.
Warnings:
• Use for intended purpose
• Contains removable parts
• Use caution when installing
• Do not over-tighten the Wing Head Thumb Screw
For use with flagpoles up to 3/4" diameter.
Installation Instructions
Read all information included
1. Pull the Quick Release Pin from the body of the Flag Holder Bracket.
2. Attach the Flag Holder Bracket to the rail of your pontoon
the Pivot Lock is in the open position.
3. Once you have the bracket attached, return the Pivot Lock to the closed position
Pin back into place.
4. Loosen the Wing Head Thumb
Wing Head Thumb Screw until the flagpole
Product Satisfaction
At Extreme Max, we pride ourselves
not 100% satisfied with the product, for any reason, please reach out to us. We are here to help!
Warranty
This product is warranted for consumer
Warranty valid only in the USA.
This product is warranted to the original
wear and tear expected. This warranty
of goods or any acts of vandalism
commercial use. The sole remedy under this warranty
or similar product, or the refund of the original
incidental damages. Any and all freight charges to handle warranty
MaxTM is not responsible for any labor charges that may be incurred.
For all inquries please send your
summary of alleged defect and any applicable
Customer Service: service@extrememax.com
Locking Flag Holder Bracket
only
over water
on this page before beginning
Screw until you can easily slide the flagpole
is secured, making sure not to over-tighten.
Guarantee
on making quality
use for 2 years after the date of retail purchase. Warranty
retail purchaser to be free from defects in material
shall not apply to any defects caused by: (l) overloading,
by any person, (Ill) improper
purchase price. Extreme MaxTM is not responsible
name, mailing address,
pictures to service@extrememax.com.
Instructions
1
operation or installation.
with Wing Head Thumb
products and wish to correct any mistakes on our end. If you are
installation or use contrary
is at the discretion of manufacturer:
claims are the responsibility
main contact phone number,
I www.extrememax.com
Installation
3005.3877
4
Screw facing out. Ensure
and insert the Quick Release
into the bracket hole. Tighten the
includes parts only.
and workmanship, ordinary
(II) physical abuse
to the instructions, (IV)
the replacement of the same
for any consequential
of the consumer.
original retail sales receipt,
3
2
or
Extreme
3518ex0121