THOMSON VS 360 Manuel D'utilisation page 10

VS 360/460 - 9 langues
Improvement of picture and sound
You will obtain optimal service operation of your Video Sender by correctly orienting
the antennae (A). However, reflected signals or other signal degrading factors can affect good
quality signal transmission. In this case, readjust antennae positions or slightly move the
transmitter or receiver until you get crystal clear reception.
(A)
If no picture is obtained,
check that the transmitter and the receiver have not been installed in the reverse order (each
unit corresponds either to the input or to the output of the Audio-Video signal). Check that
they have been properly connected and that they are switched on (ON position). Ensure that
the channel selector is set to the same letter on both units.
If transmission is blurred or scrambled,
choose another channel but make sure that it is identical on both units.
11/07/06 19:57 Page 8
Transmitter / Receiver
R L VIDEO IN IR EXTEND
DC 6V
AUDIO IN
Transmitter / Receiver
8
ON OFF
a, b, c, d