Adjustment Options - Thomashilfen EASyS Manuel De L'utilisateur

Adjustment options

Seat width
Loosen the hip guide screws (EASyS) / arm support screws (EASyS Modular) from the seat top surface with an Allen key (provided
with the user manual) and move the lateral elements accordingly. (Fig. 9) If the seat depth is adjusted to the minimal position, the
maximal adjustable seat width depends on the existing space between the lateral back rest upholsteries.
Seat depth
Loosen the front Allen screws (same as the hip guide setting) on the seat surface, stand facing the seat towards you and pull out the
seat plate. (Fig. 10)
Tip: For easy adjustment of the seat depth grip the frontal edge of the seat with one hand and press against the bottom part of
the backrest (concentric) with the other hand.
The hip guides (EASyS) are adjustable in depth, as well. Loosen both screws, set the desired depth, and retighten the screws. (Fig. 11)
Arm support (EASyS Modular)
The arm supports are adjustable both in height and depth. Loosen both wing nuts, set the desired height and depth, and retighten
the nuts. (Fig. 12)
Back height
Remove the lateral backrest upholstery slightly from the seat. Loosen both knurled screws at the top of the lateral tubes. (Fig. 13) The
back plate is infinitely adjustable in height. The maximum height is achieved when the locking pin clicks in audibly. Velcro fasten
the lateral backrest upholstery.
To reduce the height press down the locking pin underneath the right knurled screw and push the back plate down to the desired
height. (Fig. 14)
Back height step 2 (EASyS only)
In order to achieve the maximum back height loosen both knurled screws at the top crossbar and pull up the back plate. (Fig. 15)
Tip: The extended body guides offer additional protection to children who are primarily transported in a lying position.
Headrest (EASyS Modular only)
Insert the tube of the headrest into the receiver at the top of the headrest bracket and tighten the wing screw. (Fig. 16)
The headrest is infinitely adjustable in height by loosening the knurled screws on the rear of the backrest. (Fig. 17) To adjust the
angle of the headrest, loosen the wing screws at the headrest bracket. (Fig. 18) In addition, the headrest can be adjusted in depth by
loosening the wing screw on top of the headrest bracket. (Fig. 19) The angle of the headrest surface is adjustable both vertically and
horizontally by loosening the screws of the ball joint. (Fig. 20) Make sure to retighten all screws when adjustments are completed.
Back angle adjustment
Loosen the clamping lever and safety locking pin (fig. 21) and adjust the backrest in desired position. The seat unit automatically
slides forwards on its rails, shifting its center of gravity to maintain stability in all seat positions. (Fig. 22) Make sure to unlock the
locking pin again.
Lower leg length
Loosen the threaded pins to the side of the foot rest with the Allen key. (Fig. 23) The foot rest can be adjusted without fixed
increments. Retighten the threaded pins when adjustments are completed.
Foot angle
Loosen the 4 screws on the right and left on the bottom of the foot rest, adjust the desired angle, and retighten the screws. (Fig. 24)
Knee angle
Set the knee angle by loosening the side wing nuts on both sides. (Fig. 25)
Tip: The foot rest can be flipped up to facilitate transfers
16