Installing The Receiver; Checking The Control Functions; Inking The Transmitter And Receiver - df models RACE-X Notice D'utilisation

Installing the receiver

The installation of the receiver basically depends on the model. For this reason, you should always
follow the recommendations of the model manufacturer regarding receiver assembly. Regardless of
the model, you should always try to install the receiver so that it is protected from dust, dirt, moisture
and vibration in the best possible way. Two-sided adhesive tape (servo tape) or even rubber rings that
hold the foam-wrapped receiver securely in place are suitable for fastening.
The receiver must be mounted such that its antenna projects vertically upwards.
Installing the servo / speed controller
The installation position of a servo / the speed controller depends on the model used. However,
generally you should try to fasten the servos with rubber bushings in such a way that vibrations are
minimised.
Make sure that the entire servo range is available and the linkage rods are installed without strain.

Checking the control functions

> Connect the servos and/or speed controller used in your model and the power supply to the re-
ceiver.
> Switch on the transmitter and then the receiver.
> Prop up the model so that the front wheels are hanging freely in the air.
> Turn the steering wheel (channel 1) in clockwise direction.
The wheels should turn to the right now!
If the steering wheel is rotated counter-clockwise, the wheels should turn to the left accor-
dingly.
> If the wheels turn in the opposite direction, press the reverse switch for the steering function on
the transmitter.
> When you release the steering wheel, the wheels should turn back into the straight-ahead posi-
tion.
> If the wheels are not exactly straight in the zero position of the steering wheel, correct the posi-
tion on the trim control for the steering function (channel 1).
> The end stops of the steeringWe are unsure of the translation of this sentence. wheel should ac-
tuate the end stops to the right/left of the steering!
7. l

inKinG tHE tRAnsmittER And RECEiVER

The transmitter and receiver are already correctly preset at the factory and can be used immedia-
tely. Restoring the link is necessary only after changing the receiver and transmitter or to rectify an
error.
Carry out the following procedure to restore the link:
> Switch off the transmitter.
> For safety reasons, disconnect the servo cables from the receiver.
> Plug in the communication plug into the connection "Ch 3" on the receiver.
> Connect the receiver battery to the receiver.
The LED on the receiver starts blinking.
> Press the bind button on the transmitter and hold it down, while you switch the transmitter on.
> When the LED on the receiver stops blinking, the binding is completed.
This takes a few seconds.
> Release the bind button on the transmitter and detach the binding cable from the receiver.
> Connect the servo / speed controller back to the receiver.
> Check the functioning of the servos and the range of the remote control system.
> If the servos do not react correctly, repeat this procedure.

- -