Technical Specifications; Charging The Batteries - df models RACE-X Notice D'utilisation

3.3 Technical specifications

Transmitter
Channel number
Frequency
Modulation
Signals
Use
Undervoltage indicator (LED)
PC Link (DSC Port)
Internal charging socket
Operating voltage
Weight
Dimensions
Receiver
Channel number
Frequency
Use
Modulation
Resolution
Operating voltage
Weight
Dimensions (LxWxH)
Antenna length
Servo (no. 2002)
Metal gears, two ball bearings
Operating voltage
Actuating speed (sec/60°)
Actuating torque
Weight
Dimensions (LxWxH)
4. C
HARGinG tHE bAttERiEs
For ecological and economic reasons, we recommend the use of rechargeable batteries for operating
the remote control set. These can be directly charged in the transmitter using the charging socket
and a suitable charger.
Please follow the separate operating instructions of the battery charger used (not included
in delivery) and the specifications of the battery manufacturer.
Note that, depending on the type of battery used, several complete discharge and charge cycles are
necessary before a brand new (empty) battery supplies its maximum power.
Besides, discharge the NiMH and NiCD rechargeable batteries at regular intervals, since charging a
"half-full" rechargeable battery several times can cause a so-called memory effect. This means that
the rechargeable battery loses the charged part of its capacity. This reduces the operating time of
the model or the transmitter.
Because of the memory effect, NiMH and NiCd batteries should always be fully discharged and
should not be charged even for storage.
Discharge the rechargeable batteries completely when not in use for a long time and charge them
again just before the next use.
2 channels
2,4 GHz
GFSK
Digital signals (in 1024 steps)
Car, ship
yes (under 9V)
Jack plug (3.5mm)
yes
12V DC (8xAA)
328g
159 x 99 x 315mm
3 channels
2,4 GHz
Car, ship
GFSK
1024 steps
4.5-6V DC
5g
37.6 x 22.3 x 13mm
170mm
6V
0,16sec
9,0kgcm (88,3Ncm)
56g
41,3mm x 20,3mm x 38,7mm
1
- -