CBE P263 Mode D'emploi page 4

1
2
3
It's expressly designed to control the 12V batteries charge through solar panels.
1) Yellow LED indicating the correct
operation.
Green LED indicating the optimum charge of
2)
the battery.
3) Red LED indicating any polarity inversion of
the battery or the solar panels.
NB: Yellow and green LEDs out indicate the
poor lighting of the solar panel (e.g. the
vehicle is indoor).
It is usually any alternating of the green and
yellow LEDs.
Prearranged connector for ted test panel
4)
connection.
Prearranged red connector for display test
5)
panel Mod. PT442 connection (0 9).
LAR*€GUCATOR
TOR FOR SOLAR REGULA
CHARGE
DAYR OR
OUTPUT14.21'
INPUT 12Vcc O,
4 5
recharge
3
26
MODULE S
SOLAR 220W
INPUT 0-30V
Nominal voltage 12V.
Full-charge termination
- Charge disconnection
- Charge reconnection : 13,8V.
Typicai consumption OilmA 12V.
Serial Mosfet control.
•
Schottky diodes.
•
Max power applicable 220W.
Shon circuit and polarity inversion protected.
20A battery fuse.
Prearranged for test panels connection.
Prearranged for two solar •panels in parafiei
connection.
Dimensions: mm 160x90
•
: 14,4V.
H50