Homak FIRST WATCH Guide D'utilisation page 4

1. Decide the height that you will place the barrel rest. From this mea-
surement, cut the back wall foam into two pieces at the height that you
will place the barrel rest. Any extra that is left may be placed above the
barrel rest on the back
2. Apply the foam liner (C) to the back of the cabinet by removing about
15" of paper at the bottom (C), exposing the adhesive. Press the foam
liner into place- starting
work upward, removing the paper and smoothing the foam into place as
you go.
3. Remove the paper from barrel rest mounting bar (J) and place directly
above (C) that was applied in step 2.
4. Place bottom foam pad (B) into bottom of unit. Any extra foam can be
installed on the top of the shelf for extra protection.
After the barrel rest mounting bar has been attached during the foam
installation instructions, you may slide the barrel rests onto the mount bar
in any position. They can be moved at any time.
FOAM INSTALLATION
wall.
h" from the bottom of the cabinet. Continue to
BARREL REST
O
INSTALLATION
-4-
- 4 -