Homak FIRST WATCH Guide D'utilisation page 3

1. Install the cabinet
Locate the four
screws. Place the
a suitable location aligning
the holes on the
cabinet with two
wall that are 16" apart.
Pre-drill the holes
studs before permanently
installing cabinet.
NOTE: This cabinet
designed to be used without
securing it to a wall or other
surface. It may tip over.
2. Foam Components
The foam parts are shown below. Each part has been designed to fit into
the cabinet in a particular place. Carefully, remove the paper backing
revealing the adhesive backing and place according to the illustrations on
the following page. Once the backing has been removed and the foam is
attached to the wall it can not be removed without damage.
BOTTOM
FOAM
MECHANICAL
washers and
cabinet in
back of the
studs in the
into the
is not
FLOOR
ASSEMBLY
Mounting Holes
c
BACK
WALL
FOAM
-3-
- 3 -
Door
Lock Cylindar
BARREL REST
MOUNTING BAR