Télécharger Imprimer la page

Liens rapides

OGRESS
LIGHTING
WARNING
- IF ANY SPECIAL
CAREFULLY
TO ASSURE
CONTACT
A QUALIFIED
WARNING
- This product contains
reproductive harm
Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
8
6
2
Assembly
CAUTION:
Read instructions carefully and turn electricity off at main
circuit breaker
CONTROL
DEVICES
FULL COMPLIANCE
WITH N.E.C. REQUIREMENTS.
ELECTRICAL
CONTRACTOR
chemicals
known to the State of California
9
1
10
7
5
3
4
& Installation
panel before beginning
5485
ARE USED WITH THIS FIXTURE,
to cause cancer,
1 After Post (4) (PURCHASED SEPARATELY)
Holder (5) down on top of Post (4) and mark Post (4) at locations of
sheet metal screw holes In Post Holder (5). Remove Post Holder (5)
from Post (4) and drill one 144 inch diameter Hole (1) through Post
(4), at each mark.
2.- Connect Fixture Wires (3) to Supply Wires (2) as shown in wiring
diagram.
3.- Slip Post Holder (5) down over Post (4) and secure In place with
three Sheet Metal Screws (6).
4 - Install Lamp (NOT FURNISHED)
CAUTION: All glass ISfragile, use care when handling Lamp, Glass
Chimney (7), and Cage Assembly (10)
5.- Slip Glass Chimney (7) over Lamp and set inside Fitter (8).
6 - Place Roof Assemb ly (9) over Cage (10) and secure in place With
Capnuts (1) (DO NOT OVERTIGHTEN).
SPEC.NO
Instructions
installation.
FOLLOW
THE INSTRUCTIONS
IF THERE ARE ANY QUESTIONS,
birth defects and lor other
is installed, set Post
WHITE SUPPLY
WHITE OR IDENTIFIED
WIRE
BLACK SUPPLY
BARE, OR GREEN
BARE, OR GREEN
GROUND
WIRE
FIXTURE
FROM SUPPLY
BARE, OR GREEN
GROUND
WIRE
FROM SUPPLY
023159
04/16/09
FIXTURE
WIRE
UL LISTED
WIRE NUTS
PLAIN OR BLACK
FIXTURE
WIRE
GROUND
WIRE
GREEN
GROUND
SCREW
loading

Sommaire des Matières pour Progress Lighting 5485

  • Page 1 & Installation Instructions OGRESS LIGHTING CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. 5485 WARNING - IF ANY SPECIAL CONTROL DEVICES ARE USED WITH THIS FIXTURE, FOLLOW THE INSTRUCTIONS CAREFULLY TO ASSURE FULL COMPLIANCE WITH N.E.C.
  • Page 2 Instrucciones de ensamblaje e instalaci6n Precauciön: Lea cuidadosamente las instrucciones y desconecte la electricidad del cortacircuitos principal antes de iniciat la instalacion. ADVERTENCIA ESTE APLIQUE SE USAN DISPOSITIVOS CONTROL ESPECIALES, DEBE SEGUIR INSTRUCCIONES DETALLADAMENT PARA GARANTIZAR EL CUMPLIMTENTO E STRICTO CONEL CÖDIGO NACIONAL DE ELECTRICIDAD ( N.E.C.) Sl TIENE PREGUNTAS, COMUNfQUESECON UN ELECTRICISTACALIFICADO.