S&P PC80XP Manuel D'installation page 4

OPTION FUNCTION
If adding a Plug and Play Module (PCHSP – Humidity Sensor/PCSCP – Speed
Control/PCMHKP – Motion/Humidity Sensor, etc.), align the module as shown
in the diagram to the right. Secure the module to the housing with the screw and
connect the plug to the corresponding plug on the wire panel at the opposite
corner of the fan housing (replace the standard fan grille with a motion sensing/
lighted grille and make the additional plug connections as necessary). Refer to
the individual module accessory IOMs for more details and wiring instructions.
SERVICE PARTS
PART
1 Grille Assembly (includes part 2)
2
3 Wire Panel/Harness Assemblye
4a Blower
5a Blower Wheel
6a Motor Plate
7a Motor
4b Blower
5b Blower Wheel
6b Motor Plate
7b Motor
8
9
10
1 1 Damper/Duct Connector
a
b
c
d
* Blower Assembly includes part 4, 5, 6, 7, b,c
WARNING!: Before replacing, be sure to turn off power at power source.
WARRANTY
S&P USA Ventilation Systems, LLC. & S&P Canada Ventilation Products, Inc. warrants to the original end user of its products that our exhaust fans will be
free from defects in materials and workmanship for a period of five (5) years from the date of original purchase. 6 years warranty for motor and 5 years
warranty for the remaining fan parts. THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF SUITABILITY FOR A PARTICULAR PURPOSE.
During this five year period, S&P will, at its option, repair returned products or parts, or provide replacement products or parts, without charge, for any
product or part which is found to be defective under normal use.
This warranty does not cover normal maintenance and service or any parts that have been subject to misuse, negligence, accident, improper maintenance
or repair, faulty installation or installation contrary to recommended installation instructions.
S&P's obligation to repair or replace, at S&P's option, shall be the purchaser's sole and exclusive remedy under this warranty. No labor or materials are
covered by this warranty. S&P shall not be liable for incidental damages arising out of or in connection with product use or performance.
This warranty gives you specific legal rights. You may also have other rights which vary from state to state. To qualify for warranty service, you must notify
S&P at the address or telephone number stated below, provide the model number and part identification, and describe the nature of any defect in product
or part. You may be required to ship a defective part to S&P. There will be no charge for shipping repaired or replacement parts from S&P to you if your
address is in the United States or Canada. At the time of requesting warranty service, you must present evidence of the original purchase date.
S&P VENTILATION SYSTEMS INSTALLATION, OPERATION AND MAINTENANCE MANUAL
PART NAME
Grille Spring
PC80XP
PC1 100XP
PC150XP
Hanger Bar Kit
Housing
Wiring Plate
Screw
Screw
Screw
Screw
QUANTITY
1
11
2
d
1
10
1
9
1
1
8
1
c
1
7a
1
b
1
6a
1
5a
4
1
4a
1
1
a
3
3
5
3
2
6
1
Screw
7b
6b
5b
4b
®