Hitachi CH 10DL Instructions De Sécurité Et Mode D'emploi page 15

(3) Remove any chips and other debris from inside
the housing.
Screw (4 pc)
2. Getting a new blade ready
Taking care to prevent injury from contact with the
blade, adjust the elliptic part as shown in Fig. 15.
This places the teeth in the upper blade over the
openings in the teeth in the lower blade.
Elliptic part
CH10DL
3. Attach the crank cam and crank cam holder to the
blade. (Fig. 16)
The same type of crank cam holder is used in the
shrub shear and the grass shear. Use the crank
holder installed in the product.
Crank holder
Crank cam
Blade case
Blade
CH10DL
Bottom plate
Blade
Blade case
Crank cam
Crank cam holder
Fig. 14
Elliptic part
CG10DL
Fig. 15
Crank
Blade
holder
cover
Crank cam
Blade
CG10DL
Fig. 16
4. Attach the new blade.
(1) Align the pin on the tool with the center hole in
the crank holder. (Fig. 17)
(2) When the hexagonal part in the crank holder and
the grooves in the gear do not align, fine adjust so
that the crank holder aligns with the gear grooves.
(Fig. 18)
Fine adjust so that
the corners align
Crank holder
(3) Turn over the tool making sure that the blade does
not fall out, attach the bottom plate and secure it
with the 4 screws. (Fig. 19)
NOTE:
Be sure to check blade operation after it has been
attached. The blade and the crank cam has not
been properly fitted if the blade does not operate
correctly. Do the instructions over from the
beginning.
English
Pin
Crank holder
center hole
Fig. 17
Fig. 18
Screw (4 pc)
Bottom plate
Fig. 19
15