Replacing The Blade - Hitachi CH 10DL Instructions De Sécurité Et Mode D'emploi

English
[Trimming height guide]
The trimming height of the tool can be adjusted to three
heights by not attaching the adjuster or changing
adjuster orientation. (Fig. 10)
Approx.
10 mm
Approx.
17 mm
Approx.
25 mm
[Adjuster attachment]
(1) Turn the tool over and slide the adjuster tab in the
direction of the ribs on the tool. (Fig. 11)
Tab on
tool body
14
Adjuster
Adjuster
Fig. 10
Adjuster tab
Fig. 11
(2) Press the front end of the adjuster to fit the adjuster
onto the tool. (A clicking sound will be heard)
(Fig. 12)
[Adjuster removal]
Raise the adjuster latch to remove the adjuster. (Fig. 13)

REPLACING THE BLADE

The blade is a consumable that has to be replaced with
a new blade when it loses sharpness.
Follow the steps below to replace the blade.
The tool shown in the illustration is the shrub shear,
and it is used in examples to explain features it shares
with the grass shear.
Before replacement, turn the switch on and off until the
teeth in the upper blade are positioned over the
openings between the teeth in the lower blade.
WARNING:
Be sure to turn off the power switch and remove
the storage battery from the tool to prevent
accidents.
CAUTION:
Before blade replacement, be sure to use gloves
and attach the blade case or blade cover to prevent
the blade from coming into direct contact with
your hands or face.
1. Remove the blade. (Fig. 14)
(1) Turn the tool over, remove the four screws using
a Phillips screwdriver, remove the bottom plate
and the blade (with blade case).
(2) Remove the remaining crank holder and crank cam
from the tool. The grease used may cause the crank
holder and crank cam to stick to the blade.
Fig. 12
Latch
Fig. 13