Direct Controls - Urmet 1092/419B Manuel De L'utilisateur

5.1

DIRECT CONTROLS

POWER CONNECTOR (DC) [9]
Plug the power wire of the adapter provided into the respective DC.
ON/OFF BUTTON [5]
This is used to switch the monitor on and off. The LED lights up when the monitor is on.
    IMPORTANT NOTE
If the following message appears on the monitor after pressing the button (5):
NO SIGNAL
It means that a not connected video signal has been selected as input. To select the video signal access the MENU,
button [2].
MENU BUTTONS [2]
It allows to select the OSD Menu (On Screen Display).
AUTO BUTTON [1]
This is used to quit the OSD Menu. Press once to quit a submenu and return to the previous level. Press twice to quit the
OSD Menu.
SELECTION BUTTONS [3-4]
UP and DOWN buttons, used to move among the OSD menu items and make the available adjustments of the selected
function.
HDMI INPUT [6]
It allows the connection of an HDMI device.
VGA SIGNAL INPUT [7]
PC input.
AUDIO INPUT [8]
Audio Input signal.
NOTE: The monitor automatically detects the used video input, without any selection. If VGA signal and HDMI
signal are both connected, the selection must be done via the OSD menu.
If the image is not properly displayed, press the AUTO button you can find on the back of the monitor.
DS1092-187B 14