Publicité
Les langues disponibles
Les langues disponibles
Brake:
- When the loco speed is reduced
slowly, a "squealing" brake sound is
produced.
Note:
This requires a little practice with the
manual speed control.
Standing sounds:
- With the Multi-Train System, you
hear the boiler sounds while the
loco is standing, as well as alternat-
ing air and water pump noise.
Electronic sound
(Retrofitting for Model 2x841)
To equip this model with sound fea-
tures, we recommend the following
products:
- LGB 65000 European Steam Sound
Module
- LGB 65011 Standing Sound Power
Supply Unit (not required, when
operating an MTS Multi-Train
System)
Tip:
If the loco doesn't provide enough
space, of if you do not wish to disas-
semble it, the module may also be
placed in a coach. It can be connect-
ed to the loco using the multi-pur-
pose socket.
LGB Multi-Train System MTS
Model 2x842 with factory- installed
MTS Onboard Decoder can be oper-
ated on digital systems without any
alterations.
In digital mode, the loco has a load
readjustment function, which means
that the motor speed is kept constant
(and under normal conditions the
loco speed), even when the load of
the loco changes, for example, in
cur ves or on grades.
Note:
This feature does not work at maxi-
mum load/speed, because in that
case there would be no voltage
reserve.
18
Factory settings
Note:
Please refer to the CV list.
Remote-controlled functions
Note:
LGB remote control units are requi -
red for the following functions.
Function:
Pressing the appropriate key triggers
the functions listed below.
Function keys:
1 Whistle
2 Brake sound
3 Bell
4 Conductor announcement: "Dear
passengers: All aboard and close
the doors please! Be careful as the
train leaves."
5 Water jet blast
6 Generator
7 Steam generator off/on
8 Sound electronics off/on
Lighting key:
9 Lighting off/on
Data transmission (serial)
With older MTS components, com-
mands are transmitted as a sequence
of single commands (e.g. 3 =
1+1+1).
However, most MTS components
can be upgraded to parallel function
commands.
Exceptions:
- First generation 55000 MTS Central
Station and
- 55010 Train Mouse.
Note:
For more information, contact your
authorized retailer.
Data transmission (parallel)
When using MTS components
marked with a "P", the loco can re -
ceive "parallel" function commands,
which eliminate the pause that occurs
when a "serial" command is received.
Publicité
