Troubleshooting - Nyrius NAVS500 Guide De L'utilisateur

Émetteur numérique sans fil audio/vidéo haute définition avec extension pour télécommande ir
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before following the troubleshooting guide below please make sure that your Transmitter, Receiver and
attached equipment (HD source and display) are all properly connected switched on and not in Standby Mode.
No Video
• Check the status of the Link LEDs, and check if the HD device is working normally
• Check the HDMI lead is undamaged and is plugged into the correct socket
• Check that the correct HDMI output has been selected from the HD device's menu
• Check that the correct HDMI input has been selected from the TV menu and that the
• Make sure that it is the Receiver that is connected to the HDTV display, and the
Power LED OFF
• Make sure the power is connected, and check the power adaptor output 5V/3A DC
Transmitter Video
• Check the HD device is powered on
LED OFF
• Make sure the Transmitter is powered on
• Make sure the HD device is on, connected to the HDMI socket and outputting a
Receiver Video
• Part of the system is not properly connected or the signal received is not of good
LED is ON
• Make sure the HD display is connected, switched ON and set to the right channel/
• Check the HDMI lead is undamaged and is plugged into the correct socket
Transmitter /
• Make sure the Transmitter and Receiver are not positioned too far apart. Move
Receiver Link LED
Flashes
Bad Picture
• Make sure the HDMI leads used are undamaged and that you can get a good picture
• Make sure nothing is touching or blocking the signal to the built in antennas
• Move Transmitter and Receiver closer together
• Restart the HD device or reconnect the HDMI lead
Bad Audio/No
• Make sure that the source is outputting supported audio formats
Audio
• If the audio signal drops out, Restart the audio source and reconnect the HDMI lead
• Make sure there is no 5.8GHz wireless phone within 50cm of the Receiver. Some
Other Issues/
• If any other issue occurs of if the above issues persist, try switching OFF both
Unresolved Issues
For further questions or inquires, please contact NYRIUS customer support at:

TROUBLESHOOTING

and that the HDMI lead is plugged into the correct output socket
HDMI lead is plugged into the input socket selected
Transmitter that is connected to your HD device
supported resolution (1080p, 1080i, 720p, 720i, 576p, 576i, 480p, 480i). The Green
LED will switch OFF if an unsupported video signal is output
enough quality/strength
input (e.g. HDMI channel)
them closer together to check minimum effective range. Make sure the HD device is
switched ON and had been connected to Transmitter
when the source is connected directly to the display with an HDMI lead
phones use substandard transmission schemes
Transmitter and Receiver and repeating the link set-up process
1-800-663-5954 or email support@NYRIUS.com
- 6 -

Publicité

Chapitres

Table des Matières
loading

Table des Matières